Search among more than user manuals and view them online Find great deals for Aton DLA4 Four Room Speaker Switch With Volume Control. Shop with confidence on eBay!. Free Shipping on many items across the worlds largest range of Aton Dla4 In Home Audio Equalizers. Find the perfect Christmas gift ideas with eBay.
|Published (Last):||24 August 2012|
|PDF File Size:||11.96 Mb|
|ePub File Size:||20.20 Mb|
|Price:||Free* [*Free Regsitration Required]|
Verify that the impedance levels of the amp and speaker are not lower than 8 Ohms. Set the volume in each room to the desired level. Set the Zone 2 volume level to the point where it achieves the maximum qton level prior to distortion. Test known good speaker at back panel speaker connector b.
Adjust the volume as required.
This equipment generates, uses and can radiate radio frequency energy and, if not in-stalled and used in accordance with the instructions, may cause harmful interference to radio communications.
This is a single-source application: Please report the problem to your dealer immediately. Add an optional RF remote and receiver in order to have full control anywhere in the house.
Press the Room Button for the desired room. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus including amplifiers that produce heat. To set a Scene Preset: Figure and Table provide descriptions and locations of Front Panel controls and indicators.
Ground loop Ensure proper grounding using a three prong grounded AC outlet. If within the applicable warranty period above purchaser discovers that such item was not as warranted above and promptly contacts ATON at or service atonhome. Mild to moderate IR Flooding. These limits are designed to provide reasonable protection rla4 harmful interference in a residential installation.
At atom, turn off the audio throughout the entire house. Without releasing the Room button, press and hold the Vol – Button. Figure and Table provide description and location of Rear Panel connections. When using this setting, maximum volume is reduced to 10 steps.
Follow these guidelines to ensure your device is preserved and protected.
Aton DLA4 Four Room Speaker Switch With Volume Control | eBay
Press Play, turn ON, etc. Remote Control batteries are dead Replace batteries 1. Turn a knob, and the volume goes up or down. Increase the separation between the equipment and receiver.
Provisions exist zton IR, Ground, and Voltage. Remote Control Options Option 1: ATON strongly recommends that you do not add more speakers than recommended.
Protect the power dl4a cord from being walked on or pinched, particularly at plugs, outlets and the point where they exit from the apparatus. This application provides independent control of each area within a sub-zone. Verify connections No audio present in any room Hum or buzz through system speakers Poor audio quality 26 1.
Make sure to match the impedance of the speakers and ampliers as noted.
Aton DLA4 Four Room Speaker Switch With Volume Control
Use Rack screws not included to attach the assembled unit to the equipment rack as ato in Figure D Place the receiver in a convenient location; preferably as high as possible. The RF Receiver Base utilizes mounting holes to mount the unit to a wall, cabinet or other surface. Speakers out of phase Carefully check polarity of each speaker 3.